2. Pull the cover straight back and away from the product, and then remove two thumb screws
(calloutl).
Figure Remove the formatter cover and formatter cage
3. Grasp the formatter cage by the finger holes, and then slide it away from the product to remove it.
If NOTE: When you reinstall the formatter cage, open the formatter-cage door before you fully seat the formatter cage, and verify that the formatter PCA connector is aligned with the connector on the product chassis.
Figure Remove the formatter cover and formatter cage
Reinstallation notes, formatter
If you install a replacement formatter, complete the following steps:
1. Use the control-panel display to open the service menu and specify the total page count, the
maintenance count, the service ID, the cold reset paper size, and the serial number.
2. Reset the product display language to the customers choice (see the Operation chapter).
After installing a new formatter, complete the following steps:
1. Remove the memory DIMM from the discarded formatter, and then install the DIMM on the
replacement formatter.
2. Turn the product on and then wait for five minutes after the product reaches the Ready state.
NOTE: Five minutes is required to allow for NVRAM settings to be written.
Turn the product off.
4. Turn the product on again, and then wait five minutes after the product reaches the Ready state.
5. Print a configuration page to verify against original settings.
Installing a new formatter and a new DC controller
A CAUTION: If you are installing a new formatter and a new DC controller, follow the instructions in this section.
Turn the product off.
2. Remove the formatter and cage, and then replace it with the replacement formatter and cage.
3. Turn the product on and then wait for five minutes after the product reaches the Ready state.
& NOTE: Five minutes is required to allow for NVRAM settings to be written. The same five-minute wait is required several times during this procedure.
4. Turn the product off.
5. Turn the product on again, and then wait five minutes after the product reaches the Ready state.
Turn the product off.
7. Remove the DC controller (see DC controller PCA on page 188) and replace it with the new DC
controller.
8. Turn the product on and wait for five minutes after the product reaches the Ready state.
9. Turn the product off.
10. Turn the product on again, and then wait five minutes after the product reaches the Ready state.
11. Print a configuration page to verify against original settings.
0 komentar:
Posting Komentar